PDA

View Full Version : RFQ: RFQ: 3 x M5 holes drilled and tapped/ +/- 0.01mm required



neurofen
19-01-2012, 03:33 PM
hi, i'm london based but can post to the uk,

i have a small job: approx. 190x95x18mm block of aluminium(which i already have) needs 3 holes drilled and tapped to fit M5 bolts.

Drill depth needs to be 15mm.

Accuracy needs to be at least a hundredth of a mm.

Next week if possible.

The metal workers i used have closed down which is a real shame.

Thanks

Rich

Jonathan
19-01-2012, 03:48 PM
Why do you need such a tight tolerance on M5 holes?

neurofen
19-01-2012, 11:56 PM
was a little worried i got it done properly since some parts of the machine i ended up having to use 0.0125mm shims on..

to a tenth of a mm will more than likely be fine, but if id asked for that i might have someone doing it with a hand drill :/

motoxy
20-01-2012, 09:52 PM
but if id asked for that i might have someone doing it with a hand drill :/

Darn! I was going to offer as well:whistling:

Swarfing
21-01-2012, 12:31 AM
Silly question now but why don't you treat yourself to a pillar drill and centre punch and a clamp? at least you would a nice tool to use over and over again. I would not bother to do it any other way except in a drill cycle on the cnc. There does not seem like enough holes to bother setting up for that?

neurofen
23-01-2012, 01:02 PM
its a really good idea but just lost my job so very skint :(, its something i'll invest in later in the year when things are back on track..)

i may have made a break through though at the weekend after posting this thread: im trying to get my cnc finished(this job was for one of the last parts) and may well have found a way of supporting the router well enough to do this myself now, im going to give it a go..

thanks to http://www.protocnc.co.uk/gallery.aspx for the message, extremely handy to have found someone fairly locally

wish me luck

Swarfing
23-01-2012, 11:54 PM
Good luck and hope the journey is short :wink:

Jonathan
25-01-2012, 11:10 AM
I struggle to see how you could get 0.01mm accuracy with a pillar drill and a centre punch. Even on a 'normal' milling machine I think 0.01mm is asking a lot, hence why I've not offered to do it.

Swarfing
25-01-2012, 01:12 PM
Never mind then :smile:

neurofen
25-01-2012, 04:26 PM
atomic microscope might do it :D