View Full Version : NEW MEMBER: Hi
16-11-2008, 06:19 PM
Just a line to say Hello.
Two CNC machines built so far, so perhaps I can help others just starting out.
Software used :- Mach3 and Flashcut.
Machines :- Emco 220 and an Emco F1
16-11-2008, 06:41 PM
Welcome to the forum. Just in the final stages of my first machine (SWMBO says last too). Decent bunch of people here and most of us could use a bit of expert advice.
I assume one of your machines is a plasma? That was to be my next project. Don't suppose you have any pictures or a build log to post.....;)
16-11-2008, 08:29 PM
No, one is a Production Lathe with 8 tool toolchanger and the F1 is a small precision training mill.
I'll try to get some photos done.
I think a build log would take up rather a lot of space, each machine took me around 6months to convert and too much money to tell the wife about. Good experence though and trial and error a good teacher.
Powered by vBulletin® Version 4.2.3 Copyright © 2016 vBulletin Solutions, Inc. All rights reserved.