View Full Version : Your views and opinions on the Black Cat CNC Machine 600x900 please

31-05-2012, 05:21 PM
I’m looking for a machine with a cutting bed size of approx 1000x500mm. The machine is for general hobby use and therefore is required to cut Wood, Plastic and Aluminum. I would appreciate your view or experiences on the above from www.cnc3axis.com
Standard accessories included:

NCStudio Software, cable and controller.
Communication cable
Water Pump
Power cable
Clamp: 4 sets
Wrench: 2 pieces
Collet 1pc& adapter( for ф3.175 to ф6 )1pc
Bits: 8 pieces (6 pieces Flat bottom bits, 2 pieces Two spiral flute bits

Spindle spec:

Spec: 65*210 mm (Diameter:65mm x Length:210mm)
Power: 800W
Voltage: 220V~250V
Frequency: 400 Hz
Speed: 8000-24000 R/min
ER11 collet chuck

Stepper drivers:

Input Voltage: 220V-240 V, 50/60HZ
Output Voltage: 0-240 VAC
Output Power: 1.5 KW
Output Frequency: 0-400 Hz
Output Current: 7.0 A
Capacity: 2.8 KVA
Overload Capacity: 10.5 (60s)(A)

Stepper Motors:

Step Angle: 1.8 degree
Voltage: 1.8V
Current: 3.0A/phase
Resistance: 0.50hm/phase
Inductance: 1.8mH/phase
Static torque: 16.5kg-cm
Number of wire leads: 4
Length: 106 mm
Thank you