View Full Version : Orac lathe
26-06-2012, 03:56 PM
Has anyone on here re-fitted out an Orac lathe to use with Mach3.
26-06-2012, 05:25 PM
Just picked up a Orac and would like to get some ideas of what is needed to strip out and replace,
to get a working lathe.
If you are up to passing on any helpful advice it would be much appreciated.
26-06-2012, 08:51 PM
Not yet but got one stood on the floor waiting for some time.
13-07-2012, 09:05 PM
I to am just starting to do a retro fit to a denford orac, any infomation on changing the vfd to run from a pc and what drivers are recommended would be appreciated.
Powered by vBulletin® Version 4.2.3 Copyright © 2016 vBulletin Solutions, Inc. All rights reserved.