PDA

View Full Version : pulleys and belts - sizes



mocha
22-07-2012, 02:42 PM
I've read that 5mm seems to be the preferred size for pulleys, is there any specific reason for this? Would 3mm (15mm wide) cause any problems as I cant seem to squeeze 5mm pulleys (20t &40t) into the space I have available while keeping the number of teeth engaged at a reasonable number.

Any thoughts?

JAZZCNC
22-07-2012, 04:28 PM
I've read that 5mm seems to be the preferred size for pulleys, is there any specific reason for this?

Mainly because there more common and cost effective.! . . . 3mm will be fine so long has the belt width and engaged teeth is kept.

mocha
22-07-2012, 04:58 PM
Thanks jazz, 9 and 22 teeth engaged on the 20t and 40t pulleys... should be enough for Z??

JAZZCNC
22-07-2012, 05:16 PM
Thanks jazz, 9 and 22 teeth engaged on the 20t and 40t pulleys... should be enough for Z??

Yep thats fine.!