View Full Version : So... what do you plan to do over the hols?
21-12-2008, 12:10 PM
As the title says...
I have so much I want to do...
Paint my mill stand
Fit its adjustable feet
Get the mill onto the stand and set it up
Pour a new rear bearing for the lathe
Make the Z-gantry for my PCB router/mill
Change the rear pads/discs on the car, get some new tyres and get it MOT'd
and a host more...
how much will i achieve...
I suspect very little....
21-12-2008, 02:01 PM
Well, I was rather hoping to have a holiday, but I don't think it's going to happen. OTOH catching up a bit would be nice :rolleyes:
23-12-2008, 11:20 AM
Got to clear some space, just bought in injection moulder off ebay :beer:
23-12-2008, 04:12 PM
Got to clear some space, just bought in injection moulder off ebay :beer:what about the one you built? is that redundant now (and a lot smaller!)
23-12-2008, 04:31 PM
Good luck with the good intentions to do stuff over the break - I'm planning on giving my workshop a big clearout, but strongly suspect that it will still be in the present untidy state at the end of the holiday.............
23-12-2008, 08:03 PM
I built an extremely compact moulder because I didn't have the space for a big one.
I now have space. One of the basic rules of business is that that you always start from where you are now.
Here's a fun DIY injection mould link...
And a fun finishing link...
You and Jeremy, in the words of RoboCop, "Thank you for your co-operation" :beer:
Powered by vBulletin® Version 4.2.3 Copyright © 2016 vBulletin Solutions, Inc. All rights reserved.