PDA

View Full Version : Which saw to get?



Robin Hewitt
31-08-2012, 10:35 PM
Bandsaw is driving me bonkers. If I set the hydraulics to crawl it eventually cuts, if I do anything else the blade comes off. I have adjusted until I am blue in the mouth. It has to go.

I want to cut up to 6" aluminium and steel bar and tube and cut it squarely, preferably with a blade that can't come off.

What do I search for? Very hard to find what you want if you don't know what it's called. Does it even exist?

motoxy
31-08-2012, 11:23 PM
Is this the sort of saw your looking for?

SIP 01537 Pro 8 x 8 1/2inch Swivel Metal Cutting Bandsaw 1.5hp (1ph) | SIP Power Tools (http://www.sipuk.co.uk/tools/info_SIP01537.html)

Bruce

m_c
31-08-2012, 11:23 PM
Cold cut chop saw would do, but it'll cost you for something capable of 6", and blades even more expensive!

Investing in a decent bandsaw, or figuring out why the blades keep coming of would be a far cheaper investment.

Robin Hewitt
31-08-2012, 11:48 PM
Is this the sort of saw your looking for?

SIP 01537 Pro 8 x 8 1/2inch Swivel Metal Cutting Bandsaw 1.5hp (1ph) | SIP Power Tools (http://www.sipuk.co.uk/tools/info_SIP01537.html)

Bruce

Looks remarkably like the one I have but with a swivel on the blade rather than on the vice :apologetic:

Robin Hewitt
01-09-2012, 09:31 AM
I can adust the downward force using the big big spring at the back, the blade tension, the ball bearing blade guides (in out, up down and twist), the speed using a stepped pulley, the cant on the idler wheel and the feed rate on the damper piston. Two hours faffing around with it yesterday trying to cut 3 x 3/4 aluminium bar, even tried a new blade at £25 a pop. It goes so far then the blade jambs and pops off the driven wheel. It's driving me spotty.