PDA

View Full Version : FOR SALE: Steppers (3), Drives (3), Breakout board and 500w 48v PSU



deannos
10-10-2012, 06:11 PM
for sale due to change in plans and time, were only used for a couple of hours

3 X Stepper motors - 3Nm, double shaft (low inductance) (M60STH88-3008DF)
3 X Microstepping Drives - 50VDC, 4.2A (MSD542)
Parallel port breakout board
48v / 500W PSU

Looking for 180 ono including postage

JoeHarris
10-10-2012, 08:10 PM
Would you be willing to split them up?

deannos
10-10-2012, 08:30 PM
Would you be willing to split them up?

I would really like to sell them as a complete set.

audioandy
10-10-2012, 10:30 PM
You have PM

Jonathan
11-10-2012, 01:00 AM
Looks like I'm too late here. If you are willing to split I'd like then I reserve the 3 stepper motors :tongue:

audioandy
11-10-2012, 08:12 AM
Still waiting for a reply to my PM Jon I've told Dennos I'm Interested in the lot

irving2008
11-10-2012, 08:49 AM
Too late guys, I was there before you :applouse: (by about 2 hours ) but still waiting on a reply as well...

deannos
11-10-2012, 09:32 AM
Sorry about not replying but had a long day and hit the sack just after posting. I have replied to the pm's as well

Dean

irving2008
11-10-2012, 10:02 AM
Sorry about not replying but had a long day and hit the sack just after posting. I have replied to the pm's as well

Dean
No probs :biggrin:

audioandy
11-10-2012, 10:03 AM
Hi Dean

My PM has not been replied to from last night

Andy

deannos
11-10-2012, 10:16 AM
Hi Dean

My PM has not been replied to from last night

Andy

Sorry Andy, i did write a reply but must of hit the wrong button, pm now sent

WandrinAndy
11-10-2012, 10:31 AM
Too late guys, I was there before you :applouse: (by about 2 hours ) but still waiting on a reply as well...

You sure have a nose for a bargain Irving.... I'm almost starting to think that you somehow get advance notification whenever there's one going ;-)

irving2008
11-10-2012, 10:55 AM
Sadly missed many more than I caught... almost missed this one, was off to bed and logged back in to check something and couldn't resist a quick peek at 'new posts'...

The new drivers/PSU will go on the MaxNC mill I bought, will be a performance upgrade and give me a bit more speed over the current 24v system, while the new steppers will be paired up with the 70v drivers I recently got and will go towards the bigger mill... when the workshop is built... or maybe the vertical router I have made space on the wall for :smile::smile:

Lee Roberts
11-10-2012, 11:44 AM
You sure have a nose for a bargain Irving.... I'm almost starting to think that you somehow get advance notification whenever there's one going ;-)

Best thing to do is setup an RSS Feed to the forum your most intrested in, depends what program you use for RSS as to how/what options you get but its really easy to do.

.Me