PDA

View Full Version : RFQ: flat work needed



kristof
22-11-2012, 01:04 PM
Hi everyone
I need 2 frame plates cut out of carbon fibre approximetly 20cm in diameter and 1mm depth and about 6 motor holders about 4x2 cm and 2mm depth. I would supply carbon fibre plates. I attach raugh drawing. Can you tell me for how much would you do it for me?74327433

Jonathan
22-11-2012, 01:34 PM
I can make that. For the 20cm diameter part is it just the blue outline and lots of holes?

Fivetide
22-11-2012, 03:18 PM
ahh Ahhh .. the quad coptor with more arms .. project number 1010.. lol, let me know how it goes kristof

r0bsk1
22-11-2012, 03:51 PM
A hexacopter. What flight controller are you using? I have a fully autonomous hex with APM2.

kristof
22-11-2012, 10:34 PM
I can make that. For the 20cm diameter part is it just the blue outline and lots of holes?

Cool . Yes the blue outline and lots of holes.Can u give me a rough estimate?

kristof
22-11-2012, 10:39 PM
ahh Ahhh .. the quad coptor with more arms .. project number 1010.. lol, let me know how it goes kristof

I will do so:),hope I'll have enough persistence to do it, and Jonathans won't charge me too much so I can kick start:D

kristof
22-11-2012, 10:42 PM
A hexacopter. What flight controller are you using? I have a fully autonomous hex with APM2.

thats cool,please post some pictures so we can have look:),I'm planning to use mulitcopter KK V5.5 board

kristof
24-11-2012, 11:00 AM
Hello guys,have given up on me?:)can someone give me a quote,please:)