Hello from Hampshire

[gr8fun]

Hi all

I've just discovered this site while browsing the CNCZone forum.
It seems much better to have a UK based forum!

I'm currently in the planning stage of a small, probably 4ft x 4ft plasma table.
This will be used at home to prototype ideas for my small home based business.

All of this dictates I will be working on a budget! However, the good thing is the products I intend to make have little need of "fine" tolerances.

I had thought I would starting tonight.. but a recent thread has caused me to question my plans - so I'm back to square 1.

I'll not clog up the intros section with my quandary, hopefully I'll see you in the plasma section soon!!!

Ta ta for now

Danny

[martin54]

Welcome to the forum Danny, best of luck with your venture.

[Mad Professor]

Welcome to the forum, I am just over the water from you. :biggrin:

[Fivetide]

its a pitty you dont have more room , because this ones going for a steal from one of the members ! ready mad and lots of stuff

cnc plasma table with goodwin p18 plasma cutter | eBay (http://www.ebay.co.uk/itm/130807298254?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555&clk_rvr_id=416100685407&afsrc=1)

BTW hello and welcome to the forum lol

[gr8fun]

Yup, that looks the business!! and it does come with loads of kit... Sadly, for me, the cost of building a new garage to house it makes it cost prohibitive :-(

[Lee Roberts]

Hi and welcome to the forum Danny.

We dont see a great number of plasma's coming through the diy build section so its always intresting when they do, i've got no choice re new building to house a machine in !

.Me