View Full Version : Cutting Fluid

Web Goblin
12-01-2013, 07:29 PM
For a while I have been using Rocol RTD spray and found it to be very good by also very smokey by the time I had done a fair bit of cutting. I even got to the stage of installing an extractor fan in the workshop to suck out the fumes from it.
But someone gave me a tub of Rocol Ultracut Evo 250 to try. Its superb!! Used it today for the first time. 1 in 20 mix with clean water and used a small spray bottle to apply it.
Very little fumes from it and its not as clingy as the oil based stuff so the chips clear better as well. I like it alot.

12-01-2013, 07:36 PM
Water soluble is better for the majority of cutting, and is what I use for most machining.
However, pure oil is better for operations with high loads, such as tapping, and where you really don't want things to stick/gall, such as parting of in a lathe.

Web Goblin
12-01-2013, 08:05 PM
I wish I had tried it earlier. It is far better.

12-01-2013, 08:15 PM
I love the smell of Rocol in the morning, kinda smells like progress.

Web Goblin
12-01-2013, 08:31 PM
I didnt mind the smell too much. It was the smokescreen that wasnt too impressive:friendly_wink: