PDA

View Full Version : WANTED: Boxford 125TCL Chuck Wanted



JAZZCNC
29-01-2013, 09:52 PM
Hi,

Does anyone have a Boxford 125Tcl chuck for sale or could tell me where or what fits.?

Cheers

Lee Roberts
29-01-2013, 09:57 PM
Think Robbin's got one of these...

Jonathan
29-01-2013, 10:15 PM
It looks like that lathe takes an 80mm chuck, in which case a generic chuck should fit as they are standardised. You should be able to just measure the spindle register diameter, and hole positions then check them:

Lathe Chucks - Arc Euro Trade (http://www.arceurotrade.co.uk/Catalogue/Chucks/Lathe-Chucks)

They're cheaper on eBay, but the drawings there are good.

John S
29-01-2013, 10:45 PM
Can you get a cheaper degree off Ebay, I'll have to have a look.

Jonny
31-01-2013, 10:47 PM
Original Pratt and Burnerd are 82mm diameter, just measured.

JAZZCNC
31-01-2013, 11:10 PM
Original Pratt and Burnerd are 82mm diameter, just measured.

Cheers. Any chance you could take me a picture of how it fastens to spindle.?

Jonny
31-01-2013, 11:14 PM
Its under a bench, cant lift guard up.
Three cap hd screws fix to spindle close to the bore of chuck so might be very limited on what chucks will fit ie clear the scroll.

JAZZCNC
31-01-2013, 11:23 PM
Ok cheers anyway. . . . . Ye that's what I suspected has the spindle nose has threaded holes in end but thought they must be close to Bore.
I'll see what's available and then if not then I'll try to find one with correct register and maybe drill.?

Jonny
31-01-2013, 11:51 PM
Bit of rust on mine, might not show up very well.
If i get chance i will see if i can get a piccy.

Bought it three years ago and never done a thing with it.