May you please have a look at my program ?

[hoezap]

Hello


Thank you for entering inmy post




I will be veryappreciative if you may have a look at this program I made




I did invent myself thisprogram with this drawing: (see attachments)




I didn't want to use thelatest cycles that iTNC530 offer as I am quite sure I will not havethis version but some older-ones in the company where I will have myjob trial




so that's why I did inventthat way to make the 15 holes in the center and I used polarcoordinates to make those 12 m6 holes on that circumference




I ask you to payparticular attention on the parameters I used to make thatrectangular pocket about:


allowance for side


allowance for floor


tool path overlap


plunging depth




At the end I did put acountersink to clean all the bevels that the mill leaves




Any other suggestionaccording it will be very appreciative




Thank you in advance foryour help

[Peter Griffin]

On the die drawing the program is not quite correct. After the Cycle Definitions you must use Cycle call not Call label. Also the M6 command (Tool Change) should go after the Tool Define.:thumsup:

[hoezap]

On the die drawing the program is not quite correct. After the Cycle Definitions you must use Cycle call not Call label. Also the M6 command (Tool Change) should go after the Tool Define.:thumsup:

Ok I know about cycle call

About the M6 command (Tool Change) after the Tool Define, not all the heidenhain software require it

Thank you very much Peter Griffin