PDA

View Full Version : tb6560



uppy121
07-04-2013, 09:18 PM
hi
what do the folks on this site think of the 4 axis tb6560 motor driver

Ricardoco
07-04-2013, 10:15 PM
hi
what do the folks on this site think of the 4 axis tb6560 motor driver

Here are a couple of threads that will give the general idea...
http://www.mycncuk.com/forums/motor-drivers-controllers/1532-ebay-tb6560-stepper-motor-driver-boards.html

http://www.mycncuk.com/forums/motor-drivers-controllers/4276-4-axis-tb6560-cnc-driver-nema17-23-34-motor-3a-ebay-update.html

I Suspect there will be a few people using them who have no problems, but i understand they dont like to be pushed, it that is the word..


Rick

John S
07-04-2013, 10:30 PM
In a short reply - Crap

Ricardoco
07-04-2013, 10:35 PM
In a short reply - Crap

John!!

:hysterical: I was trying to be polite :hysterical:

Rick

uppy121
07-04-2013, 10:59 PM
hi
what else can i use

John S
07-04-2013, 11:09 PM
CNC Micro-Stepping Stepper Motor Driver 2M542 Bi-polar 2phase 4.2A Switch | eBay (http://www.ebay.co.uk/itm/170846930771)

Carlb1058
08-04-2013, 12:20 AM
CNC Micro-Stepping Stepper Motor Driver 2M542 Bi-polar 2phase 4.2A Switch | eBay (http://www.ebay.co.uk/itm/170846930771)

Her who must be obeyed has given me permission to buy three of 2M542's and the board that goes with 'em although I've noticed 542H - emailed the seller as to what the H is but no response yet, if I don't get one within the next few days I'll just grab the 542's as the price difference is an additional 60+/- a bit quid all up. . .

Addon Bit: Found out the difference, the 542 has a typical supply voltage of +36, whereas the 542H has a +50

Swarfing
08-04-2013, 11:39 AM
Carl

I run my 542's (or 2m542, same spec) at 42v the 'H's can run at slightly more current i believe (4.5). For your set up the standard 542's will be fine, ignore the +50 bit as well. 50v is really max for these drivers.