View Full Version : RFQ: Triac / Mach 3 help

10-08-2013, 01:59 PM
Dear all,

I am new to CNC matters but I would like help to convert a Denford Triac in the very near future to run on mach 3. It has no software at the minute

I am looking for someone who has done this type of work before idealy close to Southampton. It has a tool changer which I understand makes it tricky.

Any help at all and if you can help a guide as to what you would charge and what you would provide for that would be much appreciated.

Many thanks in advance for any help.