PDA

View Full Version : EMCO Spindle Control



Pete92
06-11-2013, 08:08 PM
Hello, sorry im being a bit of a pain during this CNC conversion. But I am learning a lot. Especially on the wiring side of things.



I hope this will be my final saga in the EMCO Conversion. I have the machines 2 axis moving fine now. All that remains is the Spindle control.



I bought the C6 board as advised on a previous thread. But I cant seem to figure out how to wire this in. I am using a HG07 break out board from CNC4YOU.



Could someone please advise me on how to set up the spindle control using these devices. I feel I could be missing a piece of the jigsaw.



Cheers,



Pete

EddyCurrent
06-11-2013, 09:20 PM
Pete,

Does this thread explain it enough ?

http://www.mycncuk.com/forums/routers-spindles-controllers/6682-how-connect-vfd-huanyang-inverter-mach3.html