stuboy
05-12-2013, 07:28 PM
I'm in London looking for a machine to engrave our aluminium faceplates, the engraving needs to be about 0.3mm deep and is from a DXF file, the units are 110mm x 110mm. Looking around I think a Roland or Gravograph might do the job? but I'm sure you will know better than me what I could use/ should use? Any suggestions welcome.
See pic for roughly what we need to do, the letters are about 8mm high.
If you have a suitable "pre loved" unit let me know :-)
Regards
Stuart
10936
See pic for roughly what we need to do, the letters are about 8mm high.
If you have a suitable "pre loved" unit let me know :-)
Regards
Stuart
10936