View Full Version : FOR SALE: Galil 1880 8 axis PCI motion controller

Boyan Silyavski
26-01-2014, 04:16 PM
for sale is used Galil DMC-1880 PCI motion controller. Works with mach3 via a plugin. Comes with 2 long 100 pin cables for the breakout boards.

I accidentally bought 2, so one has to go. 550euro shipped to your door worldwide. They sell for quite much more at ebay.

To run it on a machine you will need for 4 axis - 1 DMC-1900 or DMC-2900 breakout boards. On ebay at around 100 euro each. Or 2 of them for more than 4 axis.

Right now they sell at ebay some Galil AMP-19540 (http://www.ebay.es/itm/1-St-Galil-AMP-19540-Treiber-f-4-Motore-bis-500W-A074-/400481782762?pt=Motoren_Getriebe&hash=item5d3e930bea&_uhb=1) for 120eur, which can be used instead of the breakout boards and each of it can drive 4x500w servo motors. So quite cheaply can be formed a great setup.

Or simply the cables can be cut at the side of the enclosure and fashioned a cheap termination board, as most of the signals are opto isolated in the controller

I tested it as far as i could and updated to latest firmware. There is quite extensive manual at the Galil web how to use the controller.



PS. I have also the DMC -2183, which is the same but ethernet controller. It comes with 2 I/O boards and plugs. The same price. So if you need lan motion board i can keep the 1880.

Boyan Silyavski
03-06-2014, 07:39 PM
Just send it to ebay. No interest? I can lower a bit the price. Come on, its a steal :greedy_dollars: