Hauk
16-02-2014, 08:00 PM
Hi all!
I am a architect and modeller living in Trondheim, Norway.
I am a CNC-hobbyist, and I got my first introduction to CNC-milling in architecture school. During my studies I had access to a Datron high-speed milling machine, and I used it a lot for school projects, but also quite a few personal projects.
Here are some images:
An model railway engine containing several parts made on the Datron:
11624
Like this one:
11623
After leaving the university I have been without access to any CNC-equipment, but I have now access to a Heiz High-Z S-400. My first project on this machine is endbeams for an 0-scale mineral wagon:
11625
The coupler pocket is a brass part printed by Shapeways.
I hope there are more Heiz users on this forum!
Regards, Hauk
I am a architect and modeller living in Trondheim, Norway.
I am a CNC-hobbyist, and I got my first introduction to CNC-milling in architecture school. During my studies I had access to a Datron high-speed milling machine, and I used it a lot for school projects, but also quite a few personal projects.
Here are some images:
An model railway engine containing several parts made on the Datron:
11624
Like this one:
11623
After leaving the university I have been without access to any CNC-equipment, but I have now access to a Heiz High-Z S-400. My first project on this machine is endbeams for an 0-scale mineral wagon:
11625
The coupler pocket is a brass part printed by Shapeways.
I hope there are more Heiz users on this forum!
Regards, Hauk