View Full Version : RFQ: 10mm ali mounting plates

07-03-2014, 10:26 AM
I am in need of a number of mounting plates to be made up from 10mm ali that i can bolt my hiwin carriage to so that i can then use to bolt to my ali extrusion. I was just wondering if there was any one on here that may be able to do it before i give the job to a larger company ideally some were down south in sussex ish area would be great. Just thought i would test the water before going else were. I have all the designs on cad. some of them are 500mm long though so quite large. Drop me a message if you would be able to do it. many thanks charlie