routercnc
20-04-2014, 06:55 PM
Just been cutting out some 20mm aluminium plate this afternoon and now the machine jogs very slowly. It's stuck at around 1mm per second or so, in all axes.
I have Mach2010 screenset if that helps.
I've tried many things including going into the feedrate box at the bottom and changing it from 60 to 600, typing things into the MDI etc. but to no avial. It is stuck on a very low feedrate.
To move the machine around I've resorted to going into the 'jog' screen and selecting 'step', then selecting a large value (e.g. 5mm) and then stepping around in 5mm steps. This moves at the normal high jog speed (~20mm/sec), but clearly something is wrong.
Only had a few minutes to investigate, and now away from machine. Sure it is something easy!
I have Mach2010 screenset if that helps.
I've tried many things including going into the feedrate box at the bottom and changing it from 60 to 600, typing things into the MDI etc. but to no avial. It is stuck on a very low feedrate.
To move the machine around I've resorted to going into the 'jog' screen and selecting 'step', then selecting a large value (e.g. 5mm) and then stepping around in 5mm steps. This moves at the normal high jog speed (~20mm/sec), but clearly something is wrong.
Only had a few minutes to investigate, and now away from machine. Sure it is something easy!