PDA

View Full Version : Component Check



manofgresley
22-04-2014, 04:07 PM
Hi.
I have been converting a Hobby Mill to CNC control, it has taken a while as i have been ill throughout the winter, last week i felt fit enough to start again. I checked the wiring and started the kit up, checking voltages, fuses etc; evrything works but i cannot get the PNOZ safety relay to light up, doea anyone know a way of testing these units on a bench with a voltage regulator?

Regards

Ray

EddyCurrent
22-04-2014, 07:04 PM
Is this the one ?

http://www.mycncuk.com/forums/general-electronics/6169-pilz-relay-info.html