GASANT
25-06-2014, 06:27 PM
Hi
My homemade cnc Univelop TB6560 machine was going ok by my standards for quite some time (1.5 years) until the next day when I switched on the machine it won't run.
1) Motors - Vexta PK266-02A (Motors run 100%)
2) Univelop TB 6560 controller & Drivers
3) Mach 3 software
This is what I notice.
When I start up computer the light on Univelop BOB would light up as it always does. But as soon I start up mach 3 the light would go off.I have measured and checked voltage on DB25 parallel cable which seems ok. Have uninstalled and re-installed Mach 3 but problem persist.
I cannot understand what caused this sudden change.
Can you help please.
Thank you
Gasant
My homemade cnc Univelop TB6560 machine was going ok by my standards for quite some time (1.5 years) until the next day when I switched on the machine it won't run.
1) Motors - Vexta PK266-02A (Motors run 100%)
2) Univelop TB 6560 controller & Drivers
3) Mach 3 software
This is what I notice.
When I start up computer the light on Univelop BOB would light up as it always does. But as soon I start up mach 3 the light would go off.I have measured and checked voltage on DB25 parallel cable which seems ok. Have uninstalled and re-installed Mach 3 but problem persist.
I cannot understand what caused this sudden change.
Can you help please.
Thank you
Gasant