PDA

View Full Version : NEW MEMBER: A new start for me.......



Nthkentman
16-08-2014, 10:08 PM
Hi All,

Just an intro and saying Hi.

Just purchased an Emach (*Please* say I've not cocked up!) EM900 to produce MDF shapes letters and similar.

Hoping anyone can help out if I need some hand-holding sometime through the forums.

Thanks in advance guys n gals

deisel
17-08-2014, 12:38 PM
Get some pictures up of it ,or a link to the exact machine ,I cant find any info on them other than a few pissed off customers in the blog below
http://trickydoubt.blogspot.co.uk/?view=classic.
maybe if it came at a good price its not all bad and could be improved on.

EddyCurrent
17-08-2014, 02:45 PM
another emach thread
http://www.mycncuk.com/threads/5827-Help-with-new-machine

I'm sure that if the machine has any problems they can be sorted out here.

Nthkentman
17-08-2014, 05:21 PM
Thanks Eddycurrent... I have seen some comments and this is quite worrying. The machine apparently works and has been used, but to what degree of accuracy I am unsure.
Its an Em 900 machine built 2006, so perhaps before the rot set in.
Pics as I have them, I'm hoping it's ready to go, and if needs "Alterations" I can get them done. I'm old school C & G ONC engineer (Machinist style) and can wield a spanner, hammer, gas axe with the best of 'em :-)
Will post in correct forum a few pics

StevenT
23-08-2014, 11:50 AM
Welcome and I hope you have success with your new machine.

Steve