PDA

View Full Version : Could do with some advice on the two invertors i have aquired



Jester
20-12-2014, 03:50 PM
Well ive aquired two invertors the first is a nord sk2200/1 the second is a Yaskawa CIMR-VC2A0001BAA.

I dont know if these would be any good for spindle controllers as i usually work with massive motors.

If these are going to be any good ill need to figure out how to mains wire them (240) and wire them to the bob etc.

Any help would be appreciated.

EddyCurrent
20-12-2014, 05:20 PM
It looks like the Nord SK2200/1 is spot on for the job, single phase in, 3 phase out, 2.2kW output, max frequency 400hz
Wiring diagrams in here; https://www5.nord.com/cms/media/documents/bw/BU4100_GB_1203.pdf

Look like the Yaskawa is just 0.12 kW so a bit small I think.
http://www.optimumotomasyon.com/yaskawa-cimr-vc2a0001baa.html

Jester
20-12-2014, 06:50 PM
That ya saw a one is 2.2kw as well.

Jester
20-12-2014, 06:50 PM
Lol stupid predictive text I meant the yaskawa one is 2.2 kw as well

Jester
20-12-2014, 06:53 PM
Sorry my mistake I got the code wrong the one I have is 2.2kw lol

Jester
17-03-2015, 04:13 PM
Well after finally getting my ass into gear i started wiring up the new control box. Although i came upon quite a big problem. In my rush i made a slight oversight. I have the vfd which will run a 2,2kw spindle no probs, now my oversight.
I thought i could use my current spindle, thats a big no. the spindle i have is a cheap chinese air cooled one a DC one, and of course my VFD is AC.

So now i have to wait until i can afford a new spindle, then maybe i can start producing again.