PDA

View Full Version : NEW MEMBER: Hello from Worcestershire



petejw
25-05-2009, 08:28 PM
Hi Folks

Well, after dipping into the site for a couple of months, I finally decided I should register.

I am currently in the process of building a cnc machine and have assembled most of the bits.

Just a small affair to start with for the "Mark 1", mainly built of ply with a table size of around 300mm square. If I can make a go of it, will probably have a go at building a larger aluminium model next.

I started off with a desire to renew my old woodworking hobby after my son reignited my enthusiasm when he started woodworking classes, and this combined with some rather excellent looking wooden clocks (which my eyes are no longer good enough and my hands no longer steady enough to cut by hand) led me down the cnc route.

Maybe a bit ambitious - dunno

Cheers

Pete

audioandy
25-05-2009, 08:39 PM
Hi Pete

Welcome to the forum, don't forget photo's photo's photo's :beer:

Andy

Lee Roberts
26-05-2009, 12:05 PM
Rockon ! Clocks would be good to see, PICS PCIS PICS !

petejw
27-05-2009, 07:02 PM
Thanks for the advice, not got an e-stop on my build as yet, next on my list