PDA

View Full Version : CNC Lightsaber Project



Washout
04-06-2015, 02:10 PM
Hi All,

After showing the emerging 4th axis on my build log, I figured the continuation of the Lightsaber build should go here, as it would be off topic for that thread. New vid shows my shoddy lathe skills on my Sieg SC4 and I'm dead chuffed with the 4 jaw chuck on the tailstock and dial gauge combo (given the expertise on the forum I'll go get my welding gear on for flame protection ;) ):


https://www.youtube.com/watch?v=VTjiLLbYWXE

Also link to the first vid in case anyone missed it:

https://www.youtube.com/watch?v=H5t3Vv0bmQg

More as I get the time to work on it.......

Boyan Silyavski
06-06-2015, 06:46 AM
Great! May the force be with you!

This Jedi wants now one too...

Gary
06-06-2015, 09:42 AM
The way he is removing the swarf with his hands is not recommended. I did that once and ended up nearly cutting the end of my finger off with a length of swarf being pulled out of my hand.
Last time i did that.

Washout
16-03-2016, 04:53 PM
Hi All,

Been months since I got any time on the lathe to work on the lightsaber project, but now finally a couple of videos.

This one shows more health and safety infringements on the lathe (amongst some other nasties like trying to remember how to do threading):


https://www.youtube.com/watch?v=KGiPqtQfH-0

and this one I'm hoping gets me some way off of the watch list for cruelty to cutters ;)


https://www.youtube.com/watch?v=3bxtcLqMkas

Washout
17-05-2016, 10:33 AM
Hi all,

More shoddy lathe work in the next part of the Light Saber saga (going to have to do something about my steady rest):


https://www.youtube.com/watch?v=FdjXYtXzV3k

magicniner
17-05-2016, 06:38 PM
What will you use for a power source?

Washout
17-05-2016, 07:06 PM
Probably a small LiPo of some kind (3.7v single cell) although there is room for some of the thinner but higher capacity batteries I use for airsoft. Also depends on the circuit board and whether that has LiPo low voltage protection etc.