Boxford CNC VMC Machine Vice for sale

[jamesgates1000]

http://www.ebay.co.uk/itm/401000711471?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649

[Lee Roberts]

http://www.ebay.co.uk/itm/401000711471?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649


Damn it I forgot to bid :(

Pleased you sold it, have you got any more like this one james?

.Me

[jamesgates1000]

Hi Lee, I should have taken all the measurements when I had it, would be easy to make more and it sold for £88.

[Lee Roberts]

Hi Lee, I should have taken all the measurements when I had it, would be easy to make more and it sold for £88.

The dimensions are on the listing, don't forget?

--------------------------------
overall height 42mm
length 150mm (190mm*including*thumb screw)
width 125mm
jaw height 20mm
jaw width 100mm
max jaw opening 80mm
--------------------------------

RDG have got something similar: http://www.ebay.co.uk/itm/371117648999

Did you make the original vise you had for sale then James?

.Me

[Waine]

Hi jamesgates1000 I have a box ford vmc 260 and tcl 125 I just wondered if I could buy the stepper controllers from you if your not using them please let me know

[Clive S]

Waine
Welcome to the forum.
James seemed to have a vice for sale only so not sure where you are seeing the stepper controller.

[Waine]

Thank you Clive I saw he was converting his machine so thought he might have some parts spare because I have the updated software witch I just got from boxford and now my steppers gone

[Lee Roberts]

He did have other stuff up too, both here and eBay.

.Me

[Waine]

Thanks I'll have a look maybe I will write up a post of what I have. I like the Oxford software it's so nice to use

[jamesgates1000]

Hi guys, Lee sorry I didn't reply to your message a while back. I didn't make the vice I sold, just sold it because I needed the money, but wished I had taken all dimensions so I could of copied it exactly. They seem quite rare now so could be a good money maker!
Wayne , I sold a load of the boards and the tool carousel, but I still have the stepper drivers. They are parkers like yours but I am going to use them on my conversion when I get round to finishing it.

[Lee Roberts]

Morning, thanks for getting back to us.

I may have another one coming to me shortly instead, would you like me to post all the dimensions if so?

.Me

[uli12us]

I have the same Vice with my little 165HMC, so I can make a draft of it,
But it have a bit strange dimensions. I have measured only the distance from one thread to another from the bracket. That was 124mm over 5 threads.
That is not metric nor imperial the nearest imperial is 125/128" or metric 24,8mm. Strangely, (but good for me in a metric country) the complecte screws have metric threads.

[Waine]

Hi guys, Lee sorry I didn't reply to your message a while back. I didn't make the vice I sold, just sold it because I needed the money, but wished I had taken all dimensions so I could of copied it exactly. They seem quite rare now so could be a good money maker!
Wayne , I sold a load of the boards and the tool carousel, but I still have the stepper drivers. They are parkers like yours but I am going to use them on my conversion when I get round to finishing it.

Ok thank you if you do not want them anymore please give me first refusal they are the ones I need Parker sd3s