View Full Version : NEW MEMBER: A short introduction from your latest member,

chris w
21-11-2015, 06:22 PM
Hello guys my interests are in engineering in general as I am a machinist by day and model engineer with an interest in clocks by night, I have a manual lathe and milling machine as well as a denford triac with a fanuc control which is used regular and a denford novaturn which I have never used my latest machine is a boxford 165 HMC which I hope to convert to Mach 3, I will definatley have lots of questions some of which I may ask you to explain in a simple way.
my next challenge is learning Mach as I only use fanuc but 1 step at a Time!!
chris w.

Lee Roberts
21-11-2015, 08:56 PM
Welcome to the forum and good luck Chris.

The conversion sounds promising, feel free to fire off your questions as/when your ready, we have quite a few Boxford users on here.