PDA

View Full Version : Matching a radius



kell
01-12-2015, 04:29 AM
I have a rectangle which is on the back of a round extrusion, I would like to match the radius of the circle on the flat.
My problem is that it dose not meet on an equal part, so the radius would not be equal.
I do hope this is making sense.
Thanks

Clive S
01-12-2015, 09:39 AM
I have a rectangle which is on the back of a round extrusion, I would like to match the radius of the circle on the flat.
My problem is that it dose not meet on an equal part, so the radius would not be equal.
I do hope this is making sense.
ThanksWhy not do a drawing or sketch and post it up?

kell
01-12-2015, 11:18 AM
16666
this is the part I need to blend in the edges. Then put a radius on the flat section.