PDA

View Full Version : Chuck for Milling Machine?



Chaz
14-12-2015, 09:55 PM
Hi,

So I am looking at doing some turning work on my Denford.

Where can I get a chuck system like this?

BT30 to Chuck Plate etc or similar.

https://www.youtube.com/watch?v=j1EvkVZHSMk

uli12us
14-12-2015, 11:34 PM
Thats an easy job for your machine, you can make it all by yourself. the only problem is the clamping of the tool. If you want more than 2 tools you can add a bar above the holder with some clamp screws, similiar to the holder on the chinese copies of Deckel SO tool grinder holder for lathe tools. The round holders can easy be made from a block with 1/2"-20 threads and some drillchucks with that thread.

If you want a chuck for your workpiece, the easiest way is to use a morsetaper chuck in the machine and a lathechuck with a MT backplate. like Nr 145030 from
http://www.chronos.ltd.uk/acatalog/New_Small_Chucks_.html

Chaz
15-12-2015, 12:16 PM
Thats an easy job for your machine, you can make it all by yourself. the only problem is the clamping of the tool. If you want more than 2 tools you can add a bar above the holder with some clamp screws, similiar to the holder on the chinese copies of Deckel SO tool grinder holder for lathe tools. The round holders can easy be made from a block with 1/2"-20 threads and some drillchucks with that thread.

If you want a chuck for your workpiece, the easiest way is to use a morsetaper chuck in the machine and a lathechuck with a MT backplate. like Nr 145030 from
http://www.chronos.ltd.uk/acatalog/New_Small_Chucks_.html

Thanks, checking.