V-Groove Bit Recommendation?

[Tenson]

Hi Guys,

I'm looking for a V-Groove cutter for making 90 degree miter joins in 18mm plywood. I have a Wealden cutter (part#T128) but it has a 0.75mm flat on the end.

Can anyone recommend a suitable cutter without a flat end on it?

Thanks!

[Tenson]

Oh! Can I also please get a recommendation for veneer masking tape?

I find my usual masking tape does not stick well to veneer. I need something to put over the miter joins and hold them together when I fold them. I see a lot of people using blue stuff (Tesa?).

[Rye]

Been using a cheap 90 Degree V-Groove with a 22mm cutting edge from ebay. Cost about £ 4. Cut lots of MDF & softwood with it absolutely fine.

[Tenson]

Can you point me to the one you use? Are you sure it doesn't have a flat on the end?

[Rye]

This is the one I use: V-Groove 90 Degree (http://www.ebay.co.uk/itm/Sharp-90-Degree-CNC-Engraving-Chamfer-6mmx22mm-3D-V-Groove-Router-Bit-/121343212176?hash=item1c409e7a90:g:W~0AAOSw~gRVkWl C) (think I got mine from a different supplier.)

Cheap and cheerful but I think they're pretty good value for money.

[Tenson]

Thank you. It doesn't seem to have a deep enough DOC for 18mm, but I do also cut a lot of 9mm sheet.

The seller of this tool says it comes to a sharp point on the end - http://www.ebay.co.uk/itm/161325743965?euid=50bae376f414408ab861c4a3268f9768&cp=1&exe=12792&ext=32580&sojTags=exe=exe,ext=ext

[Sven]

I found a cheap one that was ground to a very good point so I ordered a bunch more.

Those were ground the same way, but missing the centre. Result: Flat bottom.

If you want to do 18 mm ply, you'd need a 36 mm bit. That is BIIIIIG and needs a big and powerfull spindle.
Or you'd be doing minute increments, like 0.1mm per pass as you get deeper.

[Tenson]

This is the one I use: V-Groove 90 Degree (http://www.ebay.co.uk/itm/Sharp-90-Degree-CNC-Engraving-Chamfer-6mmx22mm-3D-V-Groove-Router-Bit-/121343212176?hash=item1c409e7a90:g:W~0AAOSw~gRVkWl C) (think I got mine from a different supplier.)

Cheap and cheerful but I think they're pretty good value for money.

I just ordered a couple of those. It will do nicely for my 9mm stock.

I have a 2.2KW VFD spindle so should have enough grunt for 18mm plywood without super fine passes.