PDA

View Full Version : Steper motor rumbling



whensparksfly
15-05-2016, 03:20 PM
Hi all I 've rewired a plasma table I now have a problem now the z motor is rumbling now when it supost to be moving (not when at a stop)it seems to be fighting to move but won't move at all.

Sent from my SM-G361F using Tapatalk

lucan07
15-05-2016, 05:19 PM
See where you got the name, sounds to me as if motor is wired incorrectly double check your wiring or post some pics of motor and driver with motor and driver details.

whensparksfly
15-05-2016, 05:26 PM
Your funny. The wires match the pins and ports wires for step and direction

Sent from my SM-G361F using Tapatalk

dodgygeeza
15-05-2016, 05:40 PM
you need to give more information, without more information, it is unlikely anyone will know how to help you.

routercnc
15-05-2016, 06:32 PM
What about the wires between driver and stepper? Is each phase wired up correctly? It can damage the driver if incorrect or direct short. Are they series or parallel ?

magicniner
15-05-2016, 07:46 PM
I 've rewired a plasma table

This must have been done for a reason and will have included some changes, otherwise there was no reason to do it.
Providing these details will help, otherwise you'll have to wait until the forum crystal ball comes back from repair ;-)

- Nick

whensparksfly
22-05-2016, 06:04 PM
Got sorted the wire was broken

Sent from my SM-G361F using Tapatalk

JAZZCNC
22-05-2016, 06:14 PM
Got sorted the wire was broken

Sent from my SM-G361F using Tapatalk

Ye that's what the Crystal ball would have said.!!!

whensparksfly
22-05-2016, 06:37 PM
😊☺😄

Sent from my SM-G361F using Tapatalk

lucan07
22-05-2016, 08:04 PM
Got sorted the wire was broken

Sent from my SM-G361F using Tapatalk

As I said check the wiring, no point in going to the right pins without creating a circuit.:hysterical: I'm funny!