PDA

View Full Version : CNC Project - Custom Rack Mount Case for Firewall/Router



Washout
17-06-2016, 10:09 AM
Hi All,

Just a quick 2 part series showing a little project to secure my network using a rack mount enclosure and some CNC. I did think about posting in the recent Windows 10 thread... ;-) ):

Part 1:


https://www.youtube.com/watch?v=7kx59pY7wWU

Part 2:


https://www.youtube.com/watch?v=8GkgjPTtg0c

Lee Roberts
17-06-2016, 07:18 PM
Looking forward to this one, the computers sections would have been the other place to post it.

.Me

Washout
17-06-2016, 07:54 PM
Thanks Lee

If you can, move it on over to the computer section if you want (I don't think I can do this myself?) - I've had a few requests to do a pfsense setup tutorial, which I'll start doing shortly (its quite easy for a simple setup via a wizard), but its very powerful once you start to dig into the menus.

Cheers

Chris

magicniner
17-06-2016, 08:17 PM
Chris,
Nice one! I've given your videos a thumbs up.
Did you consider some additional venting/ducting to actively place incoming cooler air where you most want it?
Regards,
Nick

Washout
17-06-2016, 08:59 PM
Hi Nick

Thanks for the likes and yes I did consider doing another vent pattern under the motherboard so the cooler air would get sucked up under that and vented out the top. However, I don't think I'll have to, as according to the management console its running at 26.8 deg C and hasn't budged yet. If it does get near the limit in the future then I'll CNC drill the holes.

I've found on a few other consumer rack chassis that getting shot of the noisy and probably cheap crap 40mm fans and putting a 120 or 140mm fan in does wonders for cooling in switches etc.

Washout
28-06-2016, 04:59 PM
Hi all,

A bit of an update - my dual layer setup provoked a bit of comment, but I was asked so did a couple of setup videos:

Networking part:


https://www.youtube.com/watch?v=YDNLl_DyE78

and the actual setup part:


https://www.youtube.com/watch?v=RmVn4zQlDaw

Back to guitars for the next vid or three.