View Full Version : NEW MEMBER: Evening All from Aylesbury

19-06-2016, 09:50 PM
Hello chaps,

long time lurker, looking forward to picking your brains on my 1st CNC project. I'm an engineer by training and profession, mostly mechanical but with some electronics experience.

I have acquired a Denford Triac that has been completely stripped of all the power, drive and control gear. The unit is in great condition and as I couldn't see it working I got it for a song :-) My plan is to set this up to run on Mach3, it has an ATC as well but will break it down into small chunks and go slowly.

Many thanks