RocketBoy
19-06-2016, 09:50 PM
Hello chaps,
long time lurker, looking forward to picking your brains on my 1st CNC project. I'm an engineer by training and profession, mostly mechanical but with some electronics experience.
I have acquired a Denford Triac that has been completely stripped of all the power, drive and control gear. The unit is in great condition and as I couldn't see it working I got it for a song :-) My plan is to set this up to run on Mach3, it has an ATC as well but will break it down into small chunks and go slowly.
Many thanks
Mike
long time lurker, looking forward to picking your brains on my 1st CNC project. I'm an engineer by training and profession, mostly mechanical but with some electronics experience.
I have acquired a Denford Triac that has been completely stripped of all the power, drive and control gear. The unit is in great condition and as I couldn't see it working I got it for a song :-) My plan is to set this up to run on Mach3, it has an ATC as well but will break it down into small chunks and go slowly.
Many thanks
Mike