Taperlock and translock bushes
This is a discussion on Taperlock and translock bushes within the Linear & Rotary Motion forums.
- 21-03-2013 #1
iv been looking for the best method of connecting my timing pullys to the stepper mators and ball screws.
on my first build i used grubscrews directly onto the shafts and had problems with them slipping and recking the end of the shaft/screw
So having serched the forum i visited various websites recommended by various members until i came accross these at Beltingonline.com, Supplier of power transmission and conveying products
TRANSLOCK® PARALLEL SHAFT LOCKING BUSHES
the question is has anyone had any any experiance for these ?
- 22-03-2013 #2
Taperlock is by far the most common out of those two, however they're normally only available in steel, which if you want to accelerate/decelerate things fast, can add a noticeable bit of weight and affect performance. They are however common place across lots of industrial applications, meaning they're readily available.
Alloy pulleys, properly keyed on is a far lighter option, and much better where you need to change speeds quickly. I wouldn't rely soley on a radial grubscrew to transmit drive, and would look at some form of proper lock. Be that a key, drive pin, taper pin, bolt/nut, or grubscrew/bolt axially between the pulley/shaft.
Last edited by m_c; 22-03-2013 at 01:04 AM.
- 22-03-2013 #3
Another option is clamp style ones. e.g.
But not seen anyone selling them cheapish...
Last edited by bikepete; 22-03-2013 at 12:16 PM.