This is a discussion on Another Newbie within the Mills, Routers, Lathes & Commercial Machines forums.
- 27-04-2012 #41
Usually quick blast across sander, I have a flat bed sander but orbital would work just as good, and then deburr edges followed by a thrash across buffing wheel.
This pic should give an idea, unfortunatly I'd snapped them out but you can just see the thin skin which just peels away with a quick bend and when first buckle is removed others just snap off easily with a slight burr left on the edge which you can just see if you look close. These are so tiny the deburr tool won't work but with a quick rub across sander these are gone in seconds and after quick buff on polisher they are silky smooth, all in all these take me 10mins each to deburr and polish and 30mins per 4 to machine.
- 27-04-2012 #42
NEW MEMBER: Another newbieBy Stuart Winsor in forum New Member IntroductionsReplies: 1Last Post: 16-01-2014, 12:15 PM
NEW MEMBER: Not another newbie!By andyl in forum New Member IntroductionsReplies: 5Last Post: 05-02-2013, 09:55 AM
NEW MEMBER: Newbie hereBy thebigmac in forum New Member IntroductionsReplies: 1Last Post: 16-12-2012, 08:11 PM
NEW MEMBER: say hello to newbie ?By CLAYTON in forum New Member IntroductionsReplies: 1Last Post: 01-04-2011, 11:34 PM
NEW MEMBER: Yet another newbie!!By Dr Snuggles in forum New Member IntroductionsReplies: 4Last Post: 07-01-2010, 05:46 PM