- Tab Content
- johngoodrich's Activity
- About Me
- Friends
- Video Library
- Tab Content
-
Older Activity
-
8 Hours AgoThe electronics are shoehorned into the back of the machine as we didn't want a separate case, it was a tight fit getting everything in there but...8 replies | 496 view(s)
-
8 Hours AgoYes, those machines are both fixed gantry but the same can be done with a moving gantry machine and still have all the benefits be it slightly less...8 replies | 496 view(s)
-
1 Day AgoI have built several machines just like this which lift the whole gantry up, the gantry is effectively the Z axis, and they are very ridged at all...8 replies | 496 view(s)
-
4 Weeks AgoCheck the wiring, check the pin numbers, check the cable, and after this then difficult to say without being in front of the machine. Personally, I...57 replies | 12511 view(s)
-
4 Weeks AgoAh didn't realize you were using the parallel port. Well in that case then if it does it with both boards and you are sure the pin number is correct...57 replies | 12511 view(s)
-
4 Weeks AgoIf you are absolutely sure you have the correct pin numbers for the Dir pin and when you replace the wiring and it still doesn't work then yes it's a...57 replies | 12511 view(s)
About johngoodrich
Basic Information
- Age
- 41
About johngoodrich
- City:
- st austell
- Country:
- United Kingdom
Statistics
Total Posts
- Total Posts
- 216
- Posts Per Day
- 0.04
- Last Post
- Cnc router 11-06-2022
Albums
- Total Albums
- 1
- Total Photos
- 0
Total Thanks
- Total Thanks
- 1
General Information
- Last Activity
- 1 Week Ago
- Join Date
- 01-02-2008
- Referrals
- 0
Moving gantry Z axis