- Tab Content
- Doddy's Activity
- About Me
- Friends
- Video Library
-
Older Activity
-
2 Hours AgoIf you was to write a pot on the spindle controller, you should have 3 pins on the spindle controller to attach to, what are those? Likely a good...19 replies | 4376 view(s)
-
7 Hours AgoFrom what I squinted at with that particular board the circuitry was visible separate from the LV and HV sides. You’d supply the LV from the general...19 replies | 4376 view(s)
-
7 Hours AgoJohn, I've looked at the link to that board and I can't work it out - but it looks probable (PCB underside image) that the 0V reference for the 0-10V...19 replies | 4376 view(s)
-
1 Week AgoThough I'd be exploring the bullet on the S 720 feature list...14 replies | 1123 view(s)
-
1 Week Ago303 Euros?? I'd concur with the earlier recommendations of the UCxx hardware.14 replies | 1123 view(s)
-
1 Week AgoCertainly can be made to work, however, bear in mind the switching time for the relay(s) - guessing in the order of 5-10ms (I'll let you do the math...19 replies | 4376 view(s)
-
1 Week AgoWithout data sheet (I've googled for 5 minutes and given up to watch the F1 qualifying instead) - and without knowing the sensor supply voltage...19 replies | 4376 view(s)
-
3 Weeks AgoIf you don't mind, can you advise compressor model?, also, can this run/provide cooling continuously (say 1hr+.... I know that's probably short for...16 replies | 2086 view(s)
About Doddy
Basic Information
About Doddy
- City:
- Preston
- Country:
- United Kingdom
Statistics
Total Posts
- Total Posts
- 1,341
- Posts Per Day
- 0.43
- Last Post
- Triac PC Linuxcnc 2 Hours Ago
Total Thanks
- Total Thanks
- 64
General Information
- Last Activity
- 2 Hours Ago
- Join Date
- 29-12-2013
- Referrals
- 1
Triac PC Linuxcnc