. .
Tab Content
  • Doddy's Avatar
    15 Hours Ago
    Doddy replied to a thread Triac PC Linuxcnc in Denford Mills
    The copy of the manual I found online suggest pin 61 is a +12V (10mA max) regulated supply. Check that is +12V wrt the common rail (99.9% convinced...
    21 replies | 4544 view(s)
  • Doddy's Avatar
    1 Day Ago
    Doddy replied to a thread Triac PC Linuxcnc in Denford Mills
    If you was to write a pot on the spindle controller, you should have 3 pins on the spindle controller to attach to, what are those? Likely a good...
    21 replies | 4544 view(s)
  • Doddy's Avatar
    1 Day Ago
    Doddy replied to a thread Triac PC Linuxcnc in Denford Mills
    From what I squinted at with that particular board the circuitry was visible separate from the LV and HV sides. You’d supply the LV from the general...
    21 replies | 4544 view(s)
  • Doddy's Avatar
    1 Day Ago
    Doddy replied to a thread Triac PC Linuxcnc in Denford Mills
    John, I've looked at the link to that board and I can't work it out - but it looks probable (PCB underside image) that the 0V reference for the 0-10V...
    21 replies | 4544 view(s)
  • Doddy's Avatar
    1 Week Ago
    Though I'd be exploring the bullet on the S 720 feature list...
    15 replies | 1216 view(s)
  • Doddy's Avatar
    1 Week Ago
    303 Euros?? I'd concur with the earlier recommendations of the UCxx hardware.
    15 replies | 1216 view(s)
  • Doddy's Avatar
    1 Week Ago
    Doddy replied to a thread Triac PC Linuxcnc in Denford Mills
    Certainly can be made to work, however, bear in mind the switching time for the relay(s) - guessing in the order of 5-10ms (I'll let you do the math...
    21 replies | 4544 view(s)
  • Doddy's Avatar
    1 Week Ago
    Doddy replied to a thread Triac PC Linuxcnc in Denford Mills
    Without data sheet (I've googled for 5 minutes and given up to watch the F1 qualifying instead) - and without knowing the sensor supply voltage...
    21 replies | 4544 view(s)
  • Doddy's Avatar
    3 Weeks Ago
    Doddy replied to a thread Air flow in General Discussion
    If you don't mind, can you advise compressor model?, also, can this run/provide cooling continuously (say 1hr+.... I know that's probably short for...
    16 replies | 2097 view(s)
No More Results
About Doddy

Basic Information

About Doddy
City:
Preston
Country:
United Kingdom

Statistics


Total Posts
Total Posts
1,342
Posts Per Day
0.43
Last Post
Triac PC Linuxcnc 15 Hours Ago
Total Thanks
Total Thanks
64
General Information
Last Activity
34 Minutes Ago
Current Activity
Viewing Index MYCNCUK
Join Date
29-12-2013
Referrals
1

1 Friend

Showing Friends 1 to 1 of 1