. .
Tab Content
  • m_c's Avatar
    2 Weeks Ago
    To answer the OP, just get some of the 4 jaw crimpers that eBay is awash with, and make sure you give them a good squeeze when crimping the bootlaces...
    15 replies | 990 view(s)
  • m_c's Avatar
    3 Weeks Ago
    m_c replied to a thread Worn leadscrew? in General Discussion
    I had just assumed it was the Z-rails... Y the load should be spread over a larger pivot, however it'll do far more movement than the Z, so any...
    25 replies | 3968 view(s)
  • m_c's Avatar
    3 Weeks Ago
    m_c replied to a thread Worn leadscrew? in General Discussion
    If the machine is using this design - http://www.mycncuk.com/threads/10118-Finished-DIY-CNC?p=82769#post82769 I'd say it'll be putting quite a lot of...
    25 replies | 3968 view(s)
  • m_c's Avatar
    3 Weeks Ago
    Rather than start a new thread, has anybody ordered anything from China via eBay recently? In the past when I've been looking for something, I'd...
    10 replies | 2686 view(s)
No More Results
About m_c

Basic Information

About m_c
City:
East Lothian
Country:
United Kingdom

Signature


Avoiding the rubbish customer service from AluminiumWarehouse since July '13.

Statistics


Total Posts
Total Posts
2,391
Posts Per Day
0.57
Last Post
Bootlace crimping tool recommendations 2 Weeks Ago
Total Thanks
Total Thanks
6
General Information
Last Activity
9 Hours Ago
Join Date
03-09-2008
Referrals
0

1 Friend

Showing Friends 1 to 1 of 1