Lee Roberts
Find latest postsMini Statistics
- Join Date
- 27-07-2007
- Last Activity
- 1 Day Ago
- Avatar
More 24 Friends
1 Groups
Join Groups 0 Permission Groups
Lee Roberts is not a member of any public groups
Recent Visitors
This page has had 26,904 visits
- Tab Content
-
Older Activity
-
6 Days Agothe C beam is something else, for cheaper builds, does not accommodate properly square linear rails or ball screw, its more for ultra low cost builds...3 replies | 607 view(s) -
1 Week AgoSaw that yesterday in a Facebook group. Wish it was there 8 years ago. But still, a very good option. Price is good also and its in Europe, not USA...3 replies | 607 view(s)
-
1 Week AgoBoyan Silyavski replied to a thread controlling 4 linear 1000mm actuators, any ideas? in Control Hardware & SystemsFrom what i have found they could be found with hall sensors and there are devices that permit to couple 2 together. I will need 4 coupled together...3 replies | 549 view(s)
-
1 Week AgoNot to put a dampener on the op. But to me a Workbee CNC Router is not really suitable for high end toolpaths with its limited rigidity etc.8 replies | 794 view(s) -
2 Weeks AgoBoyan Silyavski started a thread controlling 4 linear 1000mm actuators, any ideas? in Control Hardware & SystemsHi, long time no see. :beer: Want to build a campervan or a trailer and have to make a lifting bed and probably lifting roof. Both using 4...3 replies | 549 view(s)
-
2 Weeks AgoHi Guys, I've now lifted the restrictions that had been placed on the Open Source forum section, at the time someone (cant remember who, I think...7 replies | 2112 view(s)
-
3 Weeks AgoRobin Hewitt replied to a thread Slide lubricant, bad alignment or not enough torque ? in General DiscussionMore might be better but I have just been playing with some dinky 5 phase steppers. They start out with a 0.8Nm pull out torque, sounds a bit limp,...20 replies | 1807 view(s) -
3 Weeks AgoRobin Hewitt replied to a thread Slide lubricant, bad alignment or not enough torque ? in General DiscussionSilicon spray can cause galling at a metal to metal sliding contact. It is famous for destroying air guns. While you clean it out you can investigate...20 replies | 1807 view(s)
2 Visitor Messages
About Lee Roberts
Basic Information
- Age
- 39
About Lee Roberts
- City:
- Wigan
- Country:
- United Kingdom
Signature
.Me
Statistics
Total Posts
- Total Posts
- 2,767
- Posts Per Day
- 0.51
- Last Post
- My CNC router MK4 F360 CAD files 2 Weeks Ago
Visitor Messages
- Total Messages
- 2
- Most Recent Message
- 05-04-2021
Total Thanks
- Total Thanks
- 730
General Information
- Last Activity
- 1 Day Ago
- Join Date
- 27-07-2007
- Referrals
- 11
24 Friends
Showing Friends 1 to 10 of 24
CO2 laser for cutting beech