Find latest postsMini Statistics
- Join Date
- 07-01-2018
- Current Activity
- Searching Forums
- Last Activity
- 1 Hour Ago
- Avatar
Recent Visitors
- Andrewg,
- Clive S,
- clutchslip,
- Doddy,
- Jack3d,
- JimJam,
- m.i.k.e,
- MikeInDevon,
- m_c,
- NB70
- Tab Content
- Muzzer's Activity
- About Me
- Video Library
-
Older Activity
-
3 Days AgoNobody seems to be able to reply to this post - I must have annoyed the timing belt gods! I hope you don't mind me pasting the guts of your PMs...2 replies | 212 view(s) -
3 Days AgoDuplicate2 replies | 212 view(s)
-
3 Days AgoI've just been testing a timing belt drive that connects a Lichuan servo motor to the cross slide ballscrew of my lathe. The parts I used are: ...2 replies | 212 view(s)
-
1 Week AgoCANbus lines only wobble up and down by a volt - so although higher signal levels can appear to make the job easier, they aren't necessary. And of...18 replies | 7394 view(s)
-
2 Weeks Ago"Conventional wisdom" is split. Some recommend only grounding one end of a screen, others recommend both. In practice, there's no right or wrong...18 replies | 7394 view(s)
-
2 Weeks AgoI usually check CPC before going to Farnell. They have been part of the same group for many years and even share the same website software and many...9 replies | 698 view(s)
-
3 Weeks AgoYou aren't far off. I agree with 720rpm. For a 2" pinion, that's 4523 in/min (multiply by pi x D). Divide by 39 (inches per meter) and 60 (seconds...5 replies | 763 view(s)
-
4 Weeks AgoMuzzer replied to a thread BUILD LOG: Comments on my first attempt at a design (if you would) in DIY Mill Build LogsYes, the carriage height in Z (top to bottom of the moving body) is very short and quite a bit less than the overhang of the spindle. Also the depth...16 replies | 1558 view(s)
About Muzzer
Basic Information
About Muzzer
- City:
- Lytham St. Annes
- Country:
- United Kingdom
Statistics
Total Posts
- Total Posts
- 273
- Posts Per Day
- 0.24
- Last Post
- Timing belt backlash?? 3 Days Ago
Total Thanks
- Total Thanks
- 5
General Information
- Last Activity
- 1 Hour Ago
- Current Activity
- Searching Forums
- Join Date
- 07-01-2018
- Referrals
- 0
Spiral toolpath to machine a cone?