- Tab Content
- Muzzer's Activity
- About Me
- Video Library
-
Older Activity
-
1 Week AgoHaha yes, I used to live up the (West) coast in Vancouver, so I was in the wrong continent for a moment too!4 replies | 551 view(s)
-
2 Weeks AgoOooof. That takes me back to 1981 when I took a year out before starting at uni. I had a job at ICI Wilton (remember them?) and I signed myself up...10 replies | 1393 view(s)
-
2 Weeks AgoMuzzer replied to a thread Slide lubricant, bad alignment or not enough torque ? in General DiscussionDunno what software you are using to drive the stepper drives but in the systems I use (LinuxCNC and Centroid), you can select the maximum pulse...20 replies | 1720 view(s)
-
3 Weeks AgoMuzzer replied to a thread Slide lubricant, bad alignment or not enough torque ? in General DiscussionAlso check the maximum step frequency and / or the minimum pulse width (similar thing). If you have it set too high frequency / too short pulse...20 replies | 1720 view(s)
About Muzzer
Basic Information
About Muzzer
- City:
- Lytham St. Annes
- Country:
- United Kingdom
Statistics
Total Posts
- Total Posts
- 369
- Posts Per Day
- 0.23
- Last Post
- New Member Portland 1 Week Ago
Total Thanks
- Total Thanks
- 7
General Information
- Last Activity
- 5 Hours Ago
- Join Date
- 07-01-2018
- Referrals
- 0
Fly cutter or surface mill to fit...