. .
Tab Content
  • Edendale's Avatar
    3 Weeks Ago
    Edendale replied to a thread Losing steps in General Discussion
    I’m saving up to come see you again ��
    11 replies | 1071 view(s)
  • Edendale's Avatar
    3 Weeks Ago
    Edendale replied to a thread Losing steps in General Discussion
    Hi Dean, you were right, I ran a file and lowered speeds & feed and it didn’t lose any steps, guess I’m just going to have to be more patient, I...
    11 replies | 1071 view(s)
  • Edendale's Avatar
    3 Weeks Ago
    Edendale replied to a thread Losing steps in General Discussion
    When I stripped it down it was sticking at the bottom of travel on Z axis, I lowed the spindle so as to miss out the bottom of screw, I try and do it...
    11 replies | 1071 view(s)
  • Edendale's Avatar
    3 Weeks Ago
    Edendale replied to a thread Losing steps in General Discussion
    When I stripped it down it was sticking at the bottom of travel on Z axis, I lowed the spindle so as to miss out the bottom of screw, I try and do it...
    11 replies | 1071 view(s)
  • Edendale's Avatar
    3 Weeks Ago
    Edendale replied to a thread Losing steps in General Discussion
    When I levelled the waste board it didn’t lose steps at all, I’ll try and do an engraving and see it it’s the same,
    11 replies | 1071 view(s)
  • Edendale's Avatar
    3 Weeks Ago
    My first attempt at 3D carving on my Chinese 6040 router came out really well and so did the next one, but now when I start the Z axis is getting...
    11 replies | 1071 view(s)
No More Results
About Edendale

Basic Information

Age
69
About Edendale
City:
Lincoln
Country:
United Kingdom
Interests:
Modelling
Occupation:
Retired

Statistics


Total Posts
Total Posts
20
Posts Per Day
0.03
Last Post
Losing steps 3 Weeks Ago
Total Thanks
Total Thanks
0
General Information
Last Activity
2 Weeks Ago
Join Date
28-01-2018
Referrals
0