. .
Tab Content
  • dazp1976's Avatar
    3 Days Ago
    Nema34 on a 24v is a no go. Having a laugh there. It will be total crap. You will get hardly any max velocity. Voltage V gives you speed. Current...
    3 replies | 267 view(s)
  • dazp1976's Avatar
    4 Days Ago
    You need to find the datasheet for the motor so we can determine the correct wire sequences. Best choice is to wire it in 'parallel' so 8 wires...
    3 replies | 267 view(s)
  • dazp1976's Avatar
    1 Week Ago
    dazp1976 replied to a thread Help Mach3 in General Discussion
    Could be the parallel port on the pc has gone then. I would get a voltmeter onto the bob. Put the +ve end on pc5v, put the -ve end on the dir pin. ...
    57 replies | 12605 view(s)
  • dazp1976's Avatar
    2 Weeks Ago
    dazp1976 replied to a thread Help Mach3 in General Discussion
    One of the wires goes in and out of COM/NC on the side that gets switched. Example: 220v+ve goes from feed+ to the pump 220v+ve. 220v-ve goes...
    57 replies | 12605 view(s)
  • dazp1976's Avatar
    2 Weeks Ago
    dazp1976 replied to a thread Help Mach3 in General Discussion
    Your 5v VCC output on those 5axis type bobs is marked PC5V. your 5v GND is marked PCGND. If using the on-board spindle relay, you cannot use P17 as...
    57 replies | 12605 view(s)
No More Results
About dazp1976

Basic Information

About dazp1976
City:
coventry
Country:
United Kingdom

Statistics


Total Posts
Total Posts
405
Posts Per Day
0.28
Last Post
Nema 34 stepper motor. 3 Days Ago
Total Thanks
Total Thanks
0
General Information
Last Activity
5 Hours Ago
Join Date
18-08-2018
Referrals
0