- Tab Content
- dazp1976's Activity
- About Me
- Video Library
-
Older Activity
-
4 Days AgoCould be the parallel port on the pc has gone then. I would get a voltmeter onto the bob. Put the +ve end on pc5v, put the -ve end on the dir pin. ...57 replies | 12109 view(s)
-
1 Week AgoOne of the wires goes in and out of COM/NC on the side that gets switched. Example: 220v+ve goes from feed+ to the pump 220v+ve. 220v-ve goes...57 replies | 12109 view(s)
-
1 Week AgoYour 5v VCC output on those 5axis type bobs is marked PC5V. your 5v GND is marked PCGND. If using the on-board spindle relay, you cannot use P17 as...57 replies | 12109 view(s)
-
3 Weeks AgoYou need a multimeter ideally. First check. End to end on your parallel cable for continuity and that the pin numbers end to end all match. If...57 replies | 12109 view(s)
-
3 Weeks AgoBroken wire or pin between controller and driver DIR terminal?. Controlling the stepper DIR simply works by switching the 5v on or off to the drive...57 replies | 12109 view(s)
About dazp1976
Basic Information
About dazp1976
- City:
- coventry
- Country:
- United Kingdom
Statistics
Total Posts
- Total Posts
- 403
- Posts Per Day
- 0.28
- Last Post
- Help Mach3 4 Days Ago
Total Thanks
- Total Thanks
- 0
General Information
- Last Activity
- 4 Hours Ago
- Join Date
- 18-08-2018
- Referrals
- 0
Wireless CNC touch probe Vers WLR