. .
Tab Content
  • dazp1976's Avatar
    3 Days Ago
    dazp1976 replied to a thread Nema 34 stepper motor. in General Discussion
    Nema34 on a 24v is a no go. Having a laugh there. It will be total crap. You will get hardly any max velocity. Voltage V gives you speed. Current...
    see more
    3 replies | 248 view(s)
  • dazp1976's Avatar
    3 Days Ago
    dazp1976 replied to a thread Nema 34 stepper motor. in General Discussion
    You need to find the datasheet for the motor so we can determine the correct wire sequences. Best choice is to wire it in 'parallel' so 8 wires...
    see more
    3 replies | 248 view(s)
  • dazp1976's Avatar
    1 Week Ago
    dazp1976 replied to a thread Help Mach3 in General Discussion
    Could be the parallel port on the pc has gone then. I would get a voltmeter onto the bob. Put the +ve end on pc5v, put the -ve end on the dir pin. ...
    see more
    57 replies | 12554 view(s)
  • dazp1976's Avatar
    2 Weeks Ago
    dazp1976 replied to a thread Help Mach3 in General Discussion
    One of the wires goes in and out of COM/NC on the side that gets switched. Example: 220v+ve goes from feed+ to the pump 220v+ve. 220v-ve goes...
    see more
    57 replies | 12554 view(s)
  • dazp1976's Avatar
    2 Weeks Ago
    dazp1976 replied to a thread Help Mach3 in General Discussion
    Your 5v VCC output on those 5axis type bobs is marked PC5V. your 5v GND is marked PCGND. If using the on-board spindle relay, you cannot use P17 as...
    see more
    57 replies | 12554 view(s)
No More Results
About dazp1976

Basic Information

About dazp1976
City:
coventry
Country:
United Kingdom

Statistics


Total Posts
Total Posts
405
Posts Per Day
0.28
Last Post
Nema 34 stepper motor. 3 Days Ago
Total Thanks
Total Thanks
0
General Information
Last Activity
4 Hours Ago
Join Date
18-08-2018
Referrals
0