- Tab Content
- depronman's Activity
- About Me
- Friends
- Video Library
-
Older Activity
-
3 Days AgoDoddy replied to a thread Panasonic MSD AC Servo - anyone ever fitted/setup one - manual driving me insane.HELP in Stepper & Servo MotorsSo, going though your questions as I see them one-by-one: "Assuming LOW was OFF?", why? - the inputs to the controller are designed to sink...2 replies | 312 view(s)
-
1 Week AgoEnjoy the hols mate Paul Sent from my iPhone using Tapatalk24 replies | 6477 view(s)
-
1 Week AgoCrap - poke me to send the second board over when I'm back in the UK (next week).24 replies | 6477 view(s)
-
1 Week AgoUpdate (which is somewhat late) Turret now under full linuxcnc control via a turret controller based on an arduino The turret controller was...24 replies | 6477 view(s)
-
1 Week AgoDoddy replied to a thread MSD043A1XXV Panasonic AC Servo Driver 400w - MB3 connection help in Stepper & Servo Motorshttps://industrial.panasonic.com/content/data/MT/PDF/MINAS-Xseries_manual_e.pdf is my "source of truth" here - please confirm yourself that it's...26 replies | 8576 view(s)
-
2 Weeks AgoFinal comment from me then I'm going back under the rock for 6 months. The control inputs to the HY VFD are fed each though onto-isolators on the...21 replies | 1945 view(s)
-
21 replies | 1945 view(s)
-
2 Weeks AgoThat's from the manual. The UCBB should be more than able to drive the inputs to the VFD. Connecting the DCM to the main controller ground (/UCBB...21 replies | 1945 view(s)
-
3 Weeks AgoNot to put a dampener on the op. But to me a Workbee CNC Router is not really suitable for high end toolpaths with its limited rigidity etc.8 replies | 937 view(s)
About depronman
Basic Information
About depronman
- City:
- St Annes on the Sea
- Country:
- United Kingdom
Statistics
Total Posts
- Total Posts
- 159
- Posts Per Day
- 0.12
- Last Post
- Denford cyclone conversion 1 Week Ago
Total Thanks
- Total Thanks
- 6
General Information
- Last Activity
- 5 Hours Ago
- Join Date
- 01-11-2018
- Referrals
- 0
Air flow